Ladder Stitch Bracelet with Lampwork Closure

——————————————————————————–

I learned these ladder stitch wrap bracelets years ago (read: decades ago), but they are enormously popular right now because of designer Chan Luu. Consider making them with a lampwork bead closure.

Hers are done with semiprecious and/or swarovski crystal and you can see them (and their prices) here:
The Wrap Bracelet

——-
Below is what you need to make a 1-yard wrap.

Materials:
Work Surface
Thumbtack
6 yards C-Lon Macrame Cord (I get it from caravan beads here: http://www.caravanbeads.net/ProdList.asp?scat=76 )
2 yards 2mm leather (available from your local bead store)
30 grams size 6/0 seed beads (also available from Caravan Beads)
Lampwork glass bead (mine is boro and you can find the tutorial to do this wave bead in this forum room. I used GA Passion Extreme and clear for this bead). The important thing about your lampwork, is that the hole must be big enough to go over TWO strands of the leather. You’ll see why as you read through this.
Twisted Wire Needles
Some glue – I suggest watch glue.
———–

Fold your leather in half. Wrap the C-lon around it and fasten with a knot.
THIS IS YOUR BUTTON HOLE! Make sure that it fits over your bead.

Stick a bit of glue on there or burn that little end with a thread burner or match (see the Shamballa Bracelet Tutorial thread in the Tutorials For Sale section on details regarding this). Pin down to your work. It’ll make it easier to start.

Thread your needle.
(Okay, I actually HATE these little wire needles, but they do make this project easier. So, swear a bit and then go ahead and thread that booger)
Thread on a size 6/0 seed bead.

**Pass the seed bead underneath and between the leather pieces.

Go OVER the lower leather piece, THROUGH the seed bead and OVER the upper leather piece.
Thread on another seed bead.** Pass the seed bead underneath and between the leather.

You probably see where this is going.
Go OVER the lower leather piece, THROUGH the seed bead and OVER the upper leather piece.

Thread on another seed bead.
Continue between the ** until you get bored.
I got bored about 4″ into this bracelet, but I was all heck-bent on making it wrap at least twice. BTW, the Chan Luu single bracelets run about $150.

When you get to the end, wrap your C-lon a few times around the leather and pull it really tight. Tie a knot and glue it. Pull your lampwork over the top of this wrap and over the top of the knot. The glue should also be inside that bead. Tie a knot on the outside of the lampwork and trim your cords.

You’re done! Admire you work!

Now, lets see photos of yours!

Related articles

• Free Beading Tutorial – Ladder Stitch Bracelet with Lampwork Closure (goodrivergallery.wordpress.com)
• Free Beading Tutorial – Steampunk Zipper & Lampwork Bead Bracelet (goodrivergallery.wordpress.com)
• Free Beading Tutorial – Bead Encrusted Big Hole Bead (goodrivergallery.wordpress.com)
• Free Beading Tutorial – Braided Necklace with Lampwork Drops Tutorial (goodrivergallery.wordpress.com)